| 1. |
HINGE
LENGTH – the length of the leaves
measured parallel to the pin. |
| 2. |
HINGE
WIDTH – the overall dimension of
the leaves measured across the knuckle. |
| 3. |
LEAF
WIDTH – the dimension from the
center of the pin to the outer edge of the leaf. |
| 4. |
KNUCKLE
LENGTH – the nominal or typical
dimension of the knuckle measured parallel to
the pin. |
| 5. |
END
PLAY – the amount of axial movement
between the leaves. |
| 6. |
PITCH
– the dimension from a point on
the knuckle to the same point on an adjacent knuckle
on the same leaf. |
| 7. |
PAINT
CLEARANCE – the minimum dimension
between the outer face of the knuckle and the
opposing edge of the leaf cut out over the entire
range of pivotal movement of the hinge. |
| |
| |
WHEN
ORDERING PLEASE SPECIFY |
| 1. |
Hinge
Length |
| 2. |
Open
Width (unequal leaves, specify leaf widths) |
| 3. |
Material
Thickness and Type |
| 4. |
Pin
Diameter |
| 5. |
Type
of Swaging |
| 6. |
Finish
Required |
| 7. |
Quantity |
| 8. |
Hinges
with Holes, Forming, etc., Need Blueprint or Sample
Provided |
